All translations

Jump to: navigation, search

Enter a message name below to show all available translations.

Message

Found one translation.

NameCurrent message text
 h English (en)==No internet no happiness==
Now we will connect WRTnode2R to the internet. of course, you must have a 2.4G Wi-Fi ap or router with has connected on the internet.<br />
 root@OpenWrt:~# aps
'aps' is the command of WRTnode2R to scan the Wi-Fi available, the output of 'aps' looks like this:<br />
<pre>
WRTnode AP scaner.
Begin scaning APs, pls wait...
Finished.
APs available are...
ra0      get_site_survey:
Ch  SSID                            BSSID              Security              Siganl(%)W-Mode  ExtCH  NT WPS DPID
1  Tenda                            xx:xx:xx:xx:xx:xx  NONE                  70      11b/g/n ABOVE  In YES
1  hshn                            xx:xx:xx:xx:xx:xx  WPA2PSK/AES            96      11b/g/n NONE  In YES
6  TP-LINK                          xx:xx:xx:xx:xx:xx  NONE                  55      11b/g  NONE  In  NO
6  BY01                            xx:xx:xx:xx:xx:xx  NONE                  100      11b/g/n NONE  In YES
6  Tenda_xxxxxx                    xx:xx:xx:xx:xx:xx  WPAPSK/AES            50      11b/g/n ABOVE  In  NO
11  CU_wpFS                          xx:xx:xx:xx:xx:xx  WPAPSK/TKIPAES        70      11b/g/n NONE  In YES
</pre>
ok,we will connect one:
 root@OpenWrt:~# setwifi SSID_you_connetctin the_password
be careful, there's a space between the SSID and the password <br />Such as:
 root@OpenWrt:~# setwifi TP_linkAB33CD my_password
Press Enter and wait 5 seconds, or sometimes we need to reconnect our computer to the WRTnode2R's SSID, so let's see if we have got the IP address from uppter router:
 root@OpenWrt:~# ia
we'll see<br />
<pre>
root@OpenWrt:~# ia
apcli0    Link encap:Ethernet  HWaddr xx:xx:xx:xx:xx:xx
         inet addr:192.168.1.103  Bcast:192.168.1.255  Mask:255.255.255.0
         inet6 addr: xxxx::xxxx:xxxx:xxxx:xxxx/xx Scope:Link
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:0 errors:0 dropped:0 overruns:0 frame:0
         TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:1000
         RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
</pre>
sometimes getting the IP address will lasts more than 5 seconds, so be patient. Once we got the IP address, let's see if the board have access the internet:<br />
<pre>
root@OpenWrt:~# ping baidu.com
PING baidu.com (220.181.111.85): 56 data bytes
64 bytes from 220.181.111.85: seq=0 ttl=54 time=6.071 ms
</pre>
See, thus we connected our computer to the WRTnode2R, and we connected the WRTnode2R to the internet.<br /><br />